Solventbased, UV-curable and Latex Inks

SI 486

Coated special paper with blue coloured back. Suitable for billboard advertising, customised mural designs (wallpaper), exhibition and shops.

Printing Systems


Art. NumberWidth (mm)GrammageLength (m)
22486.130.37700760130 g/m²50PDF
22486.130.336001370130 g/m²50PDF
22486.130.353001520130 g/m²50PDF

Technical data


  • Brilliant prints on reasonably-priced papers
  • High-quality special coatings
  • Good water resistance
  • Fast drying times
  • Good flatness qualities
  • Save on ink usage, even at low ink level, good colour saturation is possible


  • White, satin


Coating Printsidewhite, satin
Coating Backsideblueback
Width (mm)760
Grammage130 g/m²
Core Diameter76 mm
Length (m)50
Base Materialwater-resistant special paper
Packing quantity 1 roll


  • Useable on most large format Ink Jet printers using latex inks.
  • Useable on most large format Ink Jet printers using solvent ink systems.
  • Useable on most large format Ink Jet printers using UV curing ink systems.


  • Hint for gluing: For an optimal gluing of the poster, we recommend gluing the board and not the paper itself. The prints should be pre-soaked in water for 12-15 minutes and glued within 12 hours. The soaking time is extended if the print was done with high color coverage or when predominantly "black" has been printed. Insertion into the glue is not recommended.
    No more than 6 to 7 posters should be glued one upon the other to avoid the risk of detachment.

  • Note for Latex-Inks: To avoid the effect of rewetting (oil film on the print surface due to defective anchorage of ink) it is necessary to establish the optimal drying parameter. This can be done by means of print tests before production print. Rewetting can appear several days after printing when the drying condtions are defective. The rewetting can also be dependent on the given ambient conditions and the composition and consistence of the printing theme. When creating a media profile, this circumstance must be expressly taken into consideration.
  • In regard to humidity: High air humidity during the printing process may lead to banding in the direction of printing and to striations in the print image caused by the transport or press rolls.
  • Note for temperature setting: Before printing you must check that the correct drying temperature has been set by carrying out a trial print. Too high drying temperatures can lead to a deformation of the film which can later cause further problems while processing.
  • Note for Drying time / Processing: The VOC which are contained in solvent and latex inks must be fully dried before further processing. For this reason it is necessary to take long enough drying times into account. The drying time of the printed media depends very much on the quantity of solvent applied. When printing the film in a roll-to-roll process, the printed strip must be unrolled and laid flat as soon as possible until final drying. Solvent residues due to insufficient drying times can lead to blocking during transport in rolled-up form. During lamination such residues can negatively impact the quality of the finished product (flatness, shrinkage behaviour, anchorage, etc...).


  • Shelf life: 1 year after delivery
  • After printing the remaining roll must be removed from the plotter and stored in its closed original packing in a cool and dry environment.

Downloads (PDF)